Page 1 of 1

USB-BUB stopped working

Posted: Fri Apr 02, 2010 6:39 pm
by steveo
I'm using the USB-BUB interface to program a JeeNode. I've used it with success multiple times. Now it has stopped being recognized by my machine or any other (doesn't even show up as an unknown device, nothing happens). Could the chip be fried? If so, how can I verify that?

Thanks,
Steve

Re: USB-BUB stopped working

Posted: Fri Apr 02, 2010 7:19 pm
by steveo
I figured this out nearly as soon as I posted, the issue is with the mini-usb connector on the board, there's a pin with barely any contact. I just have to replace the connector.