Page 1 of 1

Burning Bootloader/Uploading Sketches To JeeNode Micro

Posted: Sat Nov 16, 2013 5:40 pm
by BobCochran10
Has anyone succeeded in burning a bootloader to the JeeNode Micro? I believe I followed the toolchain setup described here: ... 5-at-last/

But I when I try to burn the bootloader, I get an error message:

Error while burning bootloader: missing 'erase.params.verbose' configuration parameter

A screen shot of my Arduino screen is uploaded as an attachment, and hopefully I can also upload a photo of the hardware.

I have a BUB II board set to 3.3v logic which is connected to a JeeNode v6 board. On top of this is the JeeNode flash board. The flash board is connected to the JeeNode Micro.



Thanks for any help!

Bob Cochran
Greenbelt, Maryland, USA

Re: Burning Bootloader/Uploading Sketches To JeeNode Micro

Posted: Tue Nov 26, 2013 8:32 pm
by BobCochran10
This thread

which continues, gives the details of programming a bootloader to the JeeNode Micro and points the reader to a fork of jcw/ide-hardware on GitHub that contains corrected code and additional documentation. Apparently, however, a bootloader is pointless for the ATTINY84. See the comments by wolfpackmars2 and JohnO in the thread. Both contributors are more experienced with JeeNodes than me.

The challenge of uploading a sketch to the JeeNode Micro also gets attention.

Happy Thanksgiving!