Windsensor outside measurements

Questions about Modern Device and JeeLabs Sensors
Post Reply
Posts: 2
Joined: Fri Oct 24, 2014 2:07 am

Windsensor outside measurements

Post by LVX » Mon Nov 03, 2014 2:24 pm

Hi all,

I'm implementing a modern device wind sensor (rev c). And now that the test fase is over am trying the next leap,...actual wind.
Can anyone tell me if it is possible to use the windsensor in an outside environment, and if so...How?

How to shield the electronics for different weather types, off course the most harmful one,...rain.

best regards,

Site Admin
Posts: 764
Joined: Mon May 12, 2008 4:19 pm

Re: Windsensor outside measurements

Post by paul » Fri Nov 07, 2014 8:08 am


The sensor is designed to have the "prongs" cut off. Use tinsnips and carefully cut in between the two sets of three pin headers. Put the electronics in someplace dry and mount the prongs in the weather. Use silicon or some other sealant to cover the soldered leads and the cracks around the cable.

Hope that helps,


Post Reply