Zero wind adjustment(nan)

Questions about Modern Device and JeeLabs Sensors
Post Reply
vgatesr
Posts: 3
Joined: Mon May 30, 2016 9:41 pm

Zero wind adjustment(nan)

Post by vgatesr » Mon Jun 06, 2016 2:20 pm

I have two ver C wind sensors. One works as advertised. The other gives me a value of "nan" with a cover over sensor.
Values look like:
start
WindSpeed MPH nan
WindSpeed MPH nan
WindSpeed MPH 9.84
WindSpeed MPH 10.81
WindSpeed MPH 8.29
WindSpeed MPH 7.01
WindSpeed MPH 0.74
WindSpeed MPH nan
WindSpeed MPH nan

Code:"const float zeroWindAdjustment = 0.2;"
Changing the adjustment does not seem to make a difference
I suspect the device is damaged in some way but having been careful with it and examining with magnifying glass I can see not problems.
Suggestions and help with be appreciated. We went with ver C rather than P for the temp adjustment.

paul
Site Admin
Posts: 735
Joined: Mon May 12, 2008 4:19 pm

Re: Zero wind adjustment(nan)

Post by paul » Fri Dec 02, 2016 6:42 pm

vgatesr

Code:"const float zeroWindAdjustment = 0.2;"
If you can't bring it into calibration by changing the zero wind speed it MAY be damaged BUT
try zeroWindAdjustment with a negative value
Also make sure you have a solid regulated 5 volt supply to the sensor.

pb

Post Reply