Hot wire wind sensor tutorial?

Questions about Modern Device and JeeLabs Sensors
Post Reply
Posts: 1
Joined: Thu Dec 15, 2016 3:28 pm

Hot wire wind sensor tutorial?

Post by sandman » Thu Dec 15, 2016 3:37 pm

Hi guys,

is there a tutorial on how to setup the "Wind Sensor Rev. C"? I don't seem to can find anything.
I'm fairly new to this, and a step by step guide would be so nice to have.

I want to measuring airflow in a ventilation duct, where the temperature fluctuates a lot according to how cold it is outside. Does the temperature have to be stable to use this sensor?

Site Admin
Posts: 739
Joined: Mon May 12, 2008 4:19 pm

Re: Hot wire wind sensor tutorial?

Post by paul » Fri Dec 16, 2016 6:18 pm


You need to use our Arduino sketch that has software temp compensation. It's not that great but much better than no compensation.

We're still working on new models and new data.

Post Reply