A1324 Hall Effect Sensor

Questions about Modern Device and JeeLabs Sensors
Post Reply
Jarjar24
Posts: 3
Joined: Sat Mar 31, 2018 12:58 pm

A1324 Hall Effect Sensor

Post by Jarjar24 » Sat Mar 31, 2018 1:07 pm

I notice the A1324 Hall Effect Sensor has Arduino crossed out in its description. Is it not compatible with that?

paul
Site Admin
Posts: 706
Joined: Mon May 12, 2008 4:19 pm

Re: A1324 Hall Effect Sensor

Post by paul » Sat Mar 31, 2018 2:00 pm

I'm not sure why it has Arduino crossed out - I'll investigate when I get time. The sensor works best at 5 volts, but will work down to 3.3 volts with reduced accuracy.

All and all a fabulous linear output hall-effect sensor.

Paul

Jarjar24
Posts: 3
Joined: Sat Mar 31, 2018 12:58 pm

Re: A1324 Hall Effect Sensor

Post by Jarjar24 » Sun Apr 01, 2018 11:46 pm

Ok did you happen to figure out if it will work. I did order one called 1308 from somewhere that’s linear but don’t know much about it’s difference with this one

paul
Site Admin
Posts: 706
Joined: Mon May 12, 2008 4:19 pm

Re: A1324 Hall Effect Sensor

Post by paul » Mon Apr 02, 2018 12:59 pm

The A1324 will work and is dead easy to hook up.
After confirming the pinout (do this twice as I think the datasheet shows the part from the bottom view - always a bad idea IMO), hook up power and ground and run the output into an ADC (analog) pin.

Paul

Jarjar24
Posts: 3
Joined: Sat Mar 31, 2018 12:58 pm

Re: A1324 Hall Effect Sensor

Post by Jarjar24 » Mon Apr 02, 2018 2:26 pm

Awesome thank you so much for your help. I ordered them and will put them to use soon!

Post Reply