New Top

All Products By Category
Sale!
jeelabs_LED_side
jeelabs_LED_topJeelabs_LED_partsjeelabs_LED_board

JeeLabs LED Node with RGB LED Strip

$38.00 $35.50

JeeLabs LED Node v2 Kit

thumbnail
thumbnail
Clear

RGB LED Strips

Standard

Product Description

This product combines the JeeLabs LED Node with an RGB LED strip. For the LED Node alone, click here.

The LED Node v2 combines a JeeNode with 3 high-power (2A) mosfets. It is narrow (18 x 132 mm) form factor and has been designed as a good in-line fit for standard RGB LED strips.

The LED Node uses mostly through-hole parts, with the SMD MOSFET’s already soldered to the board, so it’s easy to assemble. It includes theATmega328, the RFM12B wireless module, 3 sensitive MOSFETs able to drive easily lengths of RGB LED strips (even types with 30 or 60 LEDs per meter).The MOSFET drive circuits are tied to I/O pins which support hardware PWM, providing independent flicker-free, dimming of each color. A 4-position heavy duty PCB termination matches the connections of standard RGB common-anode (common-positive) strips.

The LED Node takes its logic power from the required heavy duty supply (typically +12V regulated) which is passed on to the LED anodes. This design pays particular attention to handling relatively large currents effectively. There is provision for adding an optional thermistor for active monitoring of the MOSFET temperature, important when driving strips near the maximum (2A) recommended with high duty cycles. With more modest loading (lower maximum currents and/or duty cycle), the MOSFET’s typically stay just hand warm.

Read the ‘analog’ LED strip specification carefully. The series resistors embedded in the strip are there to limit the current draw of the individual series/parallel LED diodes. If in doubt, connect the strip directly to the power supply (that’s 100% duty cycle) and measure the current per color. The sum of these three currents must be less than the rating of the power supply and less than 3*2A, unless you add in the optional thermistor to detect and then limit excessive MOSFET temperatures. For extra long, single colour strips, the MOSFET outputs can safely wire in parallel.

Note that the LED Node does not have the full set of standard JeeNode’s “ports”. Two standard-wiring 6pin headers (Ports 1,4) are there in non-standard positions (board end and side).

Purchase Options 

  • This bundle contains a JeeLabs LED Node in the frequency of your choice and either a 1-meter long strip or a full 5-meter reel of RGB LEDs.
  • You may also buy LED strips here.

Limited stock is now available, documentation updates during Dec. 2012.

 

 Resources

  • JeeLabss blog entries this Weblog.
  • Documentation and schematics at JeeLabs.org 

Additional Information

JeeLabs LED Node v2 Kit

Weight 45 g
Dimensions 1 x 3 in
Option

Kit

Frequency

915 Mhz, 434 Mhz

Radio

RFM12B, RFM69C

RGB LED Strips

Weight 454 g
Dimensions 4 x 4 x 1 in
Option

Standard